Sunbeam 7689 User Manual
Page 6
Preparation Before Taking a Measurement
Battery Installation/Replacement
1) Slide the battery cover
off in the direction of
the arrow.
2) Install or replace the
two AA batteries, noting
the proper orientation
of positive (t) and neg-
ative (-) terminals of
the batteries in the
battery compartment.
Alkaline batteries are
recommended.
3) Replace the battery
cover.
4) If the Low Battery Symbol appears on the
display, replace both batteries.
5) Remove the batteries if the unit will not be
used for an extended period of time.
How to Apply the Wrist Cuff
(These directions are for either right or left hand
measurements.)
1) With your palm side up,
apply the cuff so that the
cuff’s edge should be
approximately to
inch from your palm. You
can use the width of your
forefinger as a simple
way to measure the dis-
tance between the cuff
and palm. (diagram
5
Diagram B