Woodstock W1713 - Manual (Page 10)

-8-
W1713 Owner's Manual (Mfg. Since 6/03)
SE
TU
P
Keep machine disconnected from
power until instructed otherwise.
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped with the Model W1713. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Box Inventory Qty
A. Scroll Saw Assembly .......................................1
B. Hex Wrench 4mm ..........................................1
C. T-Handle Hex Wrench 3mm ..............................1
D. Pin-End Blades 15 & 18 TPI ..............................2
E. Blade Guard ................................................1
F. Blade Adapters .............................................2
Inventory
The strongest workbench mounting option is a "Through
Mount" where holes are drilled all the way through the
workbench, and hex bolts, washers, and hex nuts are used
to secure the drill press to the workbench, as illustrated
in Figure 2.
Another option for mounting is a "Direct Mount" where the
machine is simply secured to the workbench with a lag
screw, as illustrated in Figure 3.
Workbench Mounting
-ACHINE
7ORKBENCH
7dai
;aViLVh]Zg
;aViLVh]Zg
AdX`LVh]Zg
=ZmCji
Figure 2. Example of a through mount.
-ACHINE
7ORKBENCH
AV\HXgZl
;aViLVh]Zg
Figure 3. Example of a direct mount.