Schumacher IP-1875C - Manual (Page 13)

• 9 •
PROBLEM POSSIBLE CAUSE REASON/SOLUTION
The Instant Power™ won’t
power my 12v device.
The 12v device is not turned
on.
The Instant Power™ battery
is not charged.
The 12v device draws more
than 15A or has a short
circuit
Turn on the 12v device.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See LED Indicators
section of this manual.
Disconnect the 12v device
and press the reset button
located on the back of the
Instant Power™. Try the 12v
device again. If it happens
again, replace the 12v device.
The battery in the Instant
Power™ won’t hold a
charge.
The battery is bad (will not
accept a charge).
have the battery checked.
BEFORE RETURNING FOR REPAIRS 14.
when a starting problem arises, make certain that the battery is capable of accepting a 14.1
normal charge. Double check all connections, the Instant Power™ battery charge level,
the battery clips for correct polarity and the quality of the connections from the cables to
the clips and from the clips to the battery system. The clips must be clean.
when an UNkNOwN OPERATINg PROBLEM arises, please read the complete manual
14.2
and call the customer service number for information that will usually eliminate the need
for return.
If the above solutions do not eliminate the problem or for information about troubleshooting, call
toll-free from anywhere in the U.S.A.
1-800-621-5485
7:00 am to 5:00 pm Central Time Monday through Friday
SPECIFICATIONS 15.
Internal Battery Type Maintenance-free AgM Lead-acid
Nominal voltage 12v DC
Capacity 18 Ah
DC Power Outlet (Max. Continuous Load) 15A
Peak Amps 950
jumper Cables 4-gauge awg (21.14 mm 2 ), 28 Inches (71 cm)
Dimensions (h x w x D) 11 x 12.75 x 7 Inches (28 x 32.5 x 17.75 cm)
Product weight 19 lbs (8.5 kgs)
REPLACEMENT PARTS/ACCESSORIES 16.
Male-To-Male Accessory cable-------------------------------------------------------94500109
Air Compressor Accessory kit (3 Adapters) ---------------------------------00-99-000599