SOYO SY-6BE+ User Manual

Page 9

SY-6BE+ Quick Start Guide

Hardware Installation

Step 6.

Clear CMOS Data (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5
seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily
identified by its white colored cap.

CMOS Clearing

Clear CMOS Data

Retain CMOS Data

JP5 Setting

Short pin 2-3 for
at least 5 seconds
to clear the CMOS.

Short pin 1-2
to retain the
new settings.

Note: You must unplug the ATX power cable from the ATX power connector when
performing the CMOS Clear operation.

Note on Over-clocking Capability

The SY-6BE+ provides over-clocking capability. Due to the over-clocking setting your system
may fail to boot up or hang during run time. Please perform the following steps to recover
your system from the abnormal situation :
1. Turn off system power. (If you use a ATX power supply, sometimes you have to press the

power button for more then 4 seconds to shut down the system)

2. Press and hold down the key while turning on the system power. Keep holding

down the key until you see the message of the CPU type and frequency shown
on the screen.

3. Press the ~~key during the system diagnostic checks to enter the Award BIOS Setup~~

program.

4. Select [SOYO COMBO SETUP] and move the cursor to the [CPU Frequency] field to set

the proper working frequency.

5. Select [Save & Exit SETUP] and press to save the new configuration to the

CMOS memory, and continue the boot sequence.

Note: SOYO does not guarantee system stability if the user over clocks the system.

Any malfunctions due to over-clocking are not covered by the warranty.