Quick bios setup – SOYO SY-6BE+ User Manual
Page 10
SY-6BE+ Quick Start Guide
10
Quick BIOS
Setup
3
3
Quick BIOS Setup
This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead,
CPU settings are software configurable with the BIOS
[SOYO COMBO SETUP]. The
[SOYO COMBO SETUP] menu combines the main parameters that you need to configure,
all in one menu, for a quick setup in BIOS.
After the hardware installation is complete, turn the power switch on, then press the
key
during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS
SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.
Step 1.
Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], then set [Hard Disk Type] to “Auto”.
Step 2.
Select [LOAD SETUP DEFAULT]
Select the “LOAD SETUP DEFAULT” menu and type “Y” at the prompt to load the BIOS
optimal setup.
Step 3.
Select [SOYO COMBO SETUP]
Move the cursor to the
[CPU Frequency] field to set the CPU frequency.
Available [CPU Frequency] settings on your SY-6BE+ Motherboard are detailed in the
following table. If you set this field to [Manual], you are then required to fill in the next two
consecutive fields: (1) the CPU Host/PCI Clock, and (2) the CPU Ratio.
CPU Frequency
233MHz (66 x 3.5)
350MHz (100 x 3.5)
266MHz (66 x 4.0)
400MHz (100 x 4.0)
300MHz (66 x 4.5)
450MHz (100 x 4.5)
333MHz (66 x 5.0)
500MHz (100 x 5.0)
366MHz (66 x 5.5)
550MHz (100 x 5.5)
400MHz (66 x 6.0)
600MHz (100 x 6.0)
433MHz (66 x 6.5)
Select the working frequency of
your Pentium
®
III, Pentium
®
II,
Celeron
processor among these
preset values.
Note:
Mark the checkbox that
corresponds to the working
frequency of your Pentium
®
III,
Pentium
®
II, Celeron
processor in
case the CMOS configuration
should be lost.
Note: if you use Bus Frequencies of 75 MHz, make sure that your PCI cards can cope with
the higher PCI clock.
Step 4.
Select [SAVE & EXIT SETUP]
Press
sequence.