SEAL 6500 User Manual
Page 8
U N P A C K I N G , S E T- U P A N D I N S T A L L A T I O N
8
UNPACKING YOUR LAMINATOR
• Remove the transport packing and the plastic shrink-
wrap the laminator is wrapped in to avoid moisture
penetration.
• Remove the accessory kit package from the top of the
laminator, which includes the necessary tools for
installation.
• Remove the foot switches from the top of the laminator
and remove the foam wrapped around them. Place a
foot switch on each side of the laminator for operator
use while feeding images.
• Remove the front and back tables (in cardboard boxes)
from the top of the laminator. Remove the tables from
the cardboard boxes and set them aside.
• Remove the protective foam wrapped around the front
and back table arms.
• Follow the Installation Instruction sheet in the accessory
pack to reattach the table arms.
• Once reattached, insert the tables into position.
• Remove the roll easel shaft from the crate and remove
the packing wrap.
• Place the roll easel shaft into the table receivers and lock
into place.
• The top rollers will go up automatically when air is
connected.
• Remove the foam placed between the top and bottom
rollers.
• Remove the stickers securing the protective paper on
the rolls using your fingers only.
• Then gently pull the paper towards you to unwind off
the roll.
WARNING! Do not use open blades to remove the
protective paper on the rollers.
• Roller damage caused by improper use of cutting tools
will void the user’s warranty. Small cuts and imperfec-
tions in the rollers greatly affect the quality of the output
and roller replacement costs are expensive.
LEVELING YOUR LAMINATOR
• Thread the leveling feet included in the accessory pack
onto each of the four transport bolts located in the
corners of the cabinets. Tighten securely.
• Use the 1/2" wrench to turn the transport bolts down
until the leveling feet are positioned flat against the floor.
• Insert a 3' x 1' (91cm x 30cm) piece of foam board
across the two center chill idlers and place the level in
the center on top of this foam board.
• Adjust the leveling feet for each side cabinet until level.
• Next, place the level on the tops of each of the cabinets
lengthwise and adjust the leveling feet from the front to
the rear of the cabinet as needed.