SEAL 6500 - Manual (Page 31)

P R O C E S S C O N T R O L S H E E T
Process: ______________________________________
Application Use: _______________________________
Top Unwind Shaft: ______________________________
Bottom Unwind Shaft: ___________________________
Front Control Panel Settings
Top Roller Temp.: ______________________________
Bottom Roller Temp.: ____________________________
Main Roller Pressure: ____________________________
Cooling Fan: On/Off ____________________________
Back Control Panel Settings
Pull Rollers: Up/Down: __________________________
Pull Roller Pressure: _____________________________
Pull Clutch Tension: _____________________________
Motor Control Panel Settings
Motor Direction: Forward/Reverse _________________
Motor Speed Setting: ____________________________
Webbing Settings
Chill Idlers: [Over/Under] 1st/2nd __________________
Web Tension Top Unwind Shaft: ___________________
Light/Med./Heavy ______________________________
Web Tension Bottom Unwind Shaft: ________________
Light/Med./Heavy ______________________________
Shim Wheel Settings: Front/Back _________________
Images: Sheet Fed/Roll Easel ______________________
NOTE: We recommend that you make a photocopy of
this page. With each successfully run application,
record the process and settings and a diagram of the
webbing procedure. Keep the record so the application
can be repeated at a later date.
HINT: If a standard image is made available for each
new process then sales materials and samples can be
developed for reference.
31
Top
Main Roller
Top
Pull Roller
Front Top
Supply Shaft
Rear Top
Supply Shaft
Bottom
Main Roller
Bottom
Pull Roller
Chill
Idler
Shim Wheel
Print Guide
Front Table
Shim Wheel
Front Rear
Front
Bottom
Wind-up
Rear
Bottom
Wind-up
Rear
Bottom
Supply
Shaft
Front
Bottom
Supply
Shaft
Rear
Roll
Easel
Front
Roll
Easel
Rear Top
Wind-up
Front Top
Wind-up
Top
Idler
Rear Table
Covered
Foot
Switch
Fan
Tube
Bott
Idler
Bott
Idler
Covered
Foot
Switch
Fan
Tube
Chill
Idler