beautypg.com

Instructions for the user – Smeg FAB40P User Manual

Page 14

background image

Instructions for the User

30

PROBLEM

POSSIBLE CAUSE

PROBABLE SOLUTION

Too much ice forming in freezer:

-

inside temperature setting
thermostat set on too low a
temperature.

- Use the regulator to set a lower

cooling temperature to increase
the temperature inside the
appliance slightly;

- check that the gaskets are

providing an airtight seal: if they
are cracked, try to soften the
gasket by pulling it with one hand
and sliding your closed fingers
along the inside;

- open the door less often and for

shorter times;

- rise in atmospheric temperature

and humidity;

- do not place hot food or drinks

inside the freezer.

Front of cabinet hot to the touch:

- the refrigerator is operating

normally. Inside the cabinet there
is a surface cooling system
designed to restrict the formation
of condensation in the area where
the door gasket closes.

Doors out of alignment:

- check that the refrigerator is

levelled properly, by also adjusting
the two rear feet if necessary.
Check whether changing the
settings of the two feet improves
the alignment.

AFTER-SALES SERVICE - READING THE NAMEPLATE.

IF THE PROBLEMS WITH THE PRODUCT YOU HAVE PURCHASED ARE NOT AMONGST THOSE
DESCRIBED ABOVE AND IF YOU NEED MORE INFORMATION, PLEASE CONTACT THE AUTHORISED
AFTER-SALES SERVICE. YOU WILL FIND THE ADDRESS AND TELEPHONE IN YOUR LOCAL TELEPHONE
DIRECTOR UNDER SMEG.

TO SPEED UP THE SERVICE, PLEASE BE READY TO INFORM OUR CALL SERVICE OPERATORS OF THE
MODEL OF THE PRODUCT YOU HAVE PURCHASED AND THE SERIAL NUMBER MARKED ON THE
NAMEPLATE INSIDE THE BODY OF THE REFRIGERATOR. THANK YOU IN ADVANCE FOR YOUR
ASSISTANCE.

This manual is related to the following products: