Sanyo PJ-NET ORGANIZER POA-PN10 - Manual (Page 44)

44
Controlling the Projector
Setting items Operation
Language Select the language used in the on-screen menu of the projector. Select your
desired language with the pull down menu button, and then press the Set button.
Keystone Correct the distortion of the projected image with the Left, Right, Up and
Down buttons. To cancel the keystone correction, press the OFF button.
Blue back When this setting is ON, the projector displays a blue image when no input
signal is selected.
Display This setting is to select whether to display the on-screen display menu.
Logo When this setting is ON, the projector displays a logo when starting up.
Ceiling When this setting is ON, the picture is reversed top/bottom and left/right.
Rear When this setting is ON the picture is reversed left/right.
No Show When this setting is ON the picture on the screen is black out.
Freeze When this setting is ON, the picture on the screen is frozen.
Power Management When this setting is ON, the projector will automatically turn the lamp off if the
input signal is interrupted and no control button is pressed for 5 minutes and
30 seconds. Set OFF to disable this function.
On Start When this setting is ON, the projector is automatically turned on just by con-
necting the AC power cord to a wall outlet.
Timer Setting Turns the projector on or off at a preselected day/date and time. Please see
chapter [Timer Setting] on the next page for more information.
Remote Control 8 different remote control codes can be set. Must be set the same code num-
ber with the remote control when this code is changed.
Lamp Counter Reset This is used to reset the lamp-use time. When replacing the lamp, reset the
lamp-use time by pressing the Yes button. Another popup window*
1 will
appear for confirmation and then press the Yes button to reset.
Lamp Mode* This is used to switch the lamp mode. When Eco is selected, the projector
reduces the brightness and sets into the low power consumption mode.
* Some projectors may not have this menu.
P-TIMER When P-TIMER button is pressed, the timer display "00:00" appears on the
screen and timer starts to count the time (00:00 ~ 59:59). To stop the time
counting, press P-TIMER button and press this button again to cancel the P-
TIMER function. The status is changed as ON -> STOP -> OFF when this but-
ton is pressed repeatedly.
The setting items and their operations are listed below.
[Note]
*1 This popup window is realized by using the JavaScript function of web browser. If the prefer-
ence of the browser is set not to use the JavaScript, the lamp counter is reset immediately
without displaying the popup window for confirmation. To display the confirmation window,
please change your preference to use the JavaScript function.
There are various kind of ways to change this preference depending on the web browser's
version and application. Please refer to chapter “Appendix: Web browser setting/Active
Script (JavaScript enable)” on page 68.