Jotul GF300 DV - Manual (Page 5)

5
Hardware Bag Contents
• Fuel Conversion Kit - LP................................ 155372
• Ember Bag , 4 oz. ............................................ 220702
General Information
„ THIS HEATER MUST BE INSTALLED AND MAINTAINED
BY A QUALIFIED SERVICE AGENCY.
„ The installation and repair of this appliance must be
done by a qualified service person. Failure to
properly install and maintain this heater could result
in an unsafe or hazardous installation, which may
result in a fire, explosion, property damage, personal
injury or loss of life.
„
This appliance should be inspected before use and at
least annually. More frequent cleaning may be
required due to excessive lint from carpeting,
bedding material, etc. It is imperative that control
compartments, burners, and circulating air passage-
ways of the appliance be kept clean.
„ THIS APPLIANCE MUST NOT BE CONNECTED TO A
CHIMNEY OR FLUE SERVING ANY OTHER APPLIANCE.
„ The installation must conform to local codes. Your
local Jøtul dealer can assist you in determining what
is required in your area for a safe and legal installa-
tion. Some areas require a permit to install a gas
burning appliance. Always consult your local
building inspector, or authority having jurisdiction,
to determine what regulations apply in your area.
„ CODE COMPLIANCE : Your local officials have final
authority in determining if a proposed installation is
acceptable. Any requirement that is requested by
the local authority having jurisdiction, that is not
specifically addressed in this manual, defaults to
local code. In the absence of local codes, the installa-
tion requirements must comply with the current
edition of National codes. In the U.S., these require-
ments are established in the National Fuel Code,
ANSI Z223.1.(NFPA 54) current edition. In Canada,
the codes have been established in CAN/CGA B149
Fuel Installation Code, current edition..
„ Installer l’appareil selon les codes ou reglements
locaux, ou, en l’absence de tels reglements, selon les
Codes d’installation CAN/CGA-B149.
„
DO NOT OPERATE THIS STOVE IF ANY PART HAS BEEN
UNDER WATER. Call a qualified service technician to
inspect the heater and to replace any part of the
control system and any gas control which may have
been under water.
„
Ne pas se servir de cet appareil s’il a ete’ plonge dans
l’eau, completement ou en partie. Appeler un
technicien qualifie pour inspecter l’appareil et
remplacer toute partie du syste’me de controle et
toute commande qui ont ete plonges dans l’eau.
THIS FIREPLACE IS SHIPPED FROM
THE FACTORY FOR USE WITH
N N N N NA A A A ATURAL GAS TURAL GAS TURAL GAS TURAL GAS TURAL GAS ONLY. IF USE WITH
PROPANE IS DESIRED, THE APPLIANCE
MUST FIRST BE CONVERTED USING
THE FUEL CONVERSION KIT
PROVIDED, #155372. CONVERSION
SHOULD BE MADE BEFORE THE
APPLIANCE IS INSTALLED. SEE PG. 17.
Glass Panel
Do not operate this appliance with the glass
front removed, cracked, or broken. Replacement
of the glass should be done by a licensed or
qualified service person. Only remove glass for
routine service. Always handle glass carefully.
Unpacking your stove
1. Remove the Top Plate of the stove by simply lifting it
straight off of the stove body.
2. To open the firebox, disengage the two Glass Frame
Latches located on top of the firebox. Pull each handle
forward to clear the latch from the notch in the
frame.
3. Familiarize yourself with the installation require-
ments specified in this manual, before beginning the
installation.
Glass Frame
Latch