Jotul GF300 DV - Manual (Page 21)

21
Log Set Installation
Brick Kit Note: Install the optional Antique Brick Kit
155370 before installing the logset. See page 27 and
the instructions provided with that kit.
The GF 300 DV logset must be installed before operat-
ing the burner. The logset includes four log pieces,
packaged inside the firebox, and a quantity of ember
stones packaged in the Miscellaneous Parts bag. To
install the log set, remove the packaging and place the
parts inside the firebox as illustrated in figs 32-36. Do
not handle the log set with your bare hands. Always
wear gloves to prevent skin irritation from the ceramic
fibers.
The ember stones realistically simulate glowing
coals when the burner is operating. These should be
spread evenly over the burner plate and around the logs. DO
NOT OBSTRUCT THE PILOT ASSEMBLY OPENING. Do not pile
up the embers in front ot the burner skirt edges. See fig. 36.
Figure 32. Engage the holes in the underside ot the Rear
Log with the two pegs in the burner skirt.
Figure 33. Install Right Log
Figure 34. Install Left Log
Figure 35. Install Middle Log
Figure 36. Position embers loosely and maintain 1/4”
clearance from the burner skirt edges.
1/4”
6 mm
1/4”
6 mm
Pilot
Assembly
NOTE: You do not need to use all of the
ember stones. With experimentation, you will
find the arrangement and quantity of embers
that works best with your stove. Depending upon
the characteristics of your installation, it is
possible that too many ember stones can pro-
mote sooting on the logs. Adjust the quantity of
ember stones as appropriate to maintain the best
overall flame picture and burner performance.
THE CERAMIC FIBER LOGS AND GLOWING EMBERS CAN
IRRITATE YOUR SKIN. GENTLY WASH YOUR HANDS WITH
WARM SOAPY WATER AFTER HANDLING THE LOGS.