JVC HR-J667MS - Manual (Page 24)

24
EN
G-CODE/SHOWVIEW
1 2 3 4 5 6 7 8
[0 – 9] =
[CANCEL] : DELETE
[PROG] : EXIT
ACCESS G-CODE/
SHOWVIEW SCREEN
1
Press PROG.
ENTER G-CODE NUMBER
2
Press the NUMBER keys to
enter the G-
CODE number
of a programme you wish
to record.
● If you make a mistake,
press CANCEL and input
the correct number.
ACCESS G-CODE
PROGRAM SCREEN
3
Press OK, and the G- CODE
Program screen appears (if
you're just starting out,
"P1" appears).
IMPORTANT
Make sure the channel position number you wish
to record is displayed; if not, see "G-
CODE Setup" on
page 22 and set the Guide Program number for that
G-
CODE number correctly.
● If the number you entered is invalid, "ERROR" appears
on the screen. Press CANCEL and input a valid G- CODE
number.
● If the "G-CODE/SHOWVIEW SETUP" screen appears,
see "ATTENTION – Regarding Guide Program
Number Set" on page 25.
SET TAPE SPEED
4
Press SP/LP/EP ( ) to set the tape speed.
– P1 –
G-CODE/SHOWVIEW123456789
START STOP
21:00 = 22:00
SP
DATE TV PROG
25.12 1
: OK
(HR-J768MS only)
G-
CODE
Timer
Programming
Before performing G- CODE Timer Programming:
● Be sure to read "G-
CODE Setup" (
੬
pg. 22).
● Insert a cassette with the safety tab in place. The recorder
will come on automatically.
● Turn on the TV and select the VIDEO channel (or AV
mode).
● Select the appropriate colour system by pressing the
COLOUR SYSTEM button (
੬
pg. 34).
With G- CODE , timer programming is greatly simplified because
each TV programme has a corresponding code number which
your recorder is able to recognise.
TIMER RECORDING (cont.)
G-CODE/SHOWVIEW
[0 – 9] =
[+/–] : EXPRESS PROGRAMING
[PROG] : EXIT
1 2 3
4 5 6
7 8 9
0
2
4
1
3 OK
NUMBER
SP/LP/EP
CANCEL
PROG
Remember, the clock must be set before you can
programme the timer (
੬
pg. 10).