JVC RX-5022VSL - Manual (Page 27)

25
Operating JVC’s Audio/Video Components
COMPU LINK Remote Control System / Operating JVC's Audio/Video Components
You can use the remote control to operate other JVC’s
components.
Operating Audio Components
IMPORTANT:
To operate JVC’s audio components using this remote control:
• You need to connect JVC’s audio components through the COMPU
LINK (SYNCHRO) jacks (see page 24) in addition to the
connections using cables with RCA pin plugs (see page 6).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 8.)
• Refer also to the manuals supplied with your audio components.
Sound Adjustment
You can always perform the following operations:
SURROUND ON/OFF : Turn on or off the Surround modes.
SURROUND MODE : Select the Surround modes.
After pressing SOUND, you can use the following buttons for sound
adjustment:
SUBWOOFER +/– : Adjust the subwoofer output level.
CENTER +/– : Adjust the center speaker output level.
REAR•L +/– : Adjust the left rear speaker output level.
REAR•R +/– : Adjust the right rear speaker output level.
EFFECT : Select the DAP effect level.
TEST : Turn on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CD-DISC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
Tuner
You can always perform the following operations:
FM/AM : Alternate between FM and AM.
FM MODE : Change the FM reception mode.
After pressing FM/AM, you can use the following buttons for tuner
operations:
1 – 10, +10 : Select a preset channel number directly.
• For channel number 5, press 5.
• For channel number 15, press +10, then 5.
• For channel number 20, press +10, then 10.
CD player
After pressing CD, you can use the following buttons for CD
operations:
3 3 3 3 3 : Start playback.
4 : Return to the beginning of the current
(or previous) track.
¢ : Skip to the beginning of the next track.
7 7 7 7 7 : Stop playback.
8 8 8 8 8 : Pause playback. To release it, press 3 3 3 3 3.
1 – 10, +10 : Select a track number directly.
• For track number 5, press 5.
• For track number 15, press +10, then 5.
• For track number 20, press +10, then 10.
FM MODE
A/V CONTROL
RECEIVER STANDBY/ON
AUDIO
TV/CATV
VCR
DVD
TEST
EFFECT
MENU
ENTER
RETURN
SOUND
SLEEP
REAR L
SUBWOOFER
PTY–PTY SEARCH–PTY
CD–DISC REC PAUSE
TAPE/CDR CD DVD
FM/AM
FM MODE
TV/VIDEO SURROUND
ON/OFF
MODE
MUTING
VCR CH TV/CATV CH TV VOLUME
VOLUME
TV SOUND VCR
ANALOG
/DIGITAL
REAR R
100
TV CATV
1
4
7/P
10
2
5
8
0
3
6
9
10
REMOTE CONTROL RM - SRX5020J
REW FF
CENTER
EN24-32.RX-5020/5022V[J]_f 01.12.7, 8:51 AM 25