JVC RX-6510VBK - Manual (Page 8)

5
English
About the speaker impedance
The required speaker impedance of the front speakers does differ
depending on whether both the FRONT SPEAKERS
1 and FRONT
SPEAKERS 2 terminals are used or only one of them is used.
Front
speaker
1
Front
speaker
1
Use front speakers with 8 Ω – 16 Ω impedance.
Front
speaker
1
Front
speaker
2
Use front speakers 16
Ω
– 32
Ω
impedance.
Front
speaker
2
Front
speaker
1
Connecting the rear and center speakers
Connect rear speakers to the REAR SPEAKERS terminals and a
center speaker to the CENTER SPEAKER terminals.
Left rear
speaker
Right rear
speaker
CENTER
SPEAKER
REAR
SPEAKERS
RIGHT LEFT
+
–
CASE 1 When you connect only one pair of front speakers
Connecting the subwoofer speaker
You can enhance the bass by connecting a subwoofer.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cable with RCA
pin plugs (not supplied).
Powered subwoofer
SUBWOOFER
OUT
Connecting Audio/Video Components
You can connect the following audio/video components to this
receiver. Refer also to the manuals supplied with your components.
Audio Components Video Components
• CD player* • DVD player*
• Cassette deck • TV*
or CD recorder* • VCR
* You can connect these components using the methods described in
“Analog connections” (below) or in “Digital connections” (see page 7).
Analog connections
Audio component connections
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, and the red plug to the
audio right jack.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
CD player
CD player
To audio output
VCR
OUT
(REC)
TAPE
CDR
CD
OUT
(REC)
IN
(PLAY)
Center
speaker
CASE 2 When you connect two pairs of front speakers
EN01_08.RX-6510VBK[C]_f 00.12.20, 2:47 PM 5