JVC RX-6510VBK - Manual (Page 36)

33
English
Manufacturer Codes
JVC 00, 02
DENON 01
PANASONIC 03
PHILIPS 13
PIONEER 04, 05, 06
RCA 07
SAMSUNG 08
SONY 09
TOSHIBA 10
YAMAHA 11, 12
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
2 3
5 6 4
8 9
MENU
ENTER
TEST
– REAR • R +
– REAR • L +
– CENTER +
To change the transmittable signals for
operating another manufacturer’s DVD player
1. Press and hold AUDIO POWER.
2. Press DVD.
3. Enter manufacturer’s code using buttons 1–9,
and 0.
See the list to the right to find the code.
4. Release AUDIO POWER.
After pressing DVD, you can perform the following operations
on a DVD player:
PLAY 3 : Starts playing.
4 : Returns to the beginning of the current (or
previous) tracks.
¢ : Skips to the beginning of the next track.
STOP 7 : Stops playing.
PAUSE 8 : Stops playing temporarily. To release it, press
PLAY
3.
After pressing DVD, these buttons
can be used for the DVD menu
operations.
Note:
For detailed menu operations, refer to the
instructions supplied with the discs or the
DVD player.
Note:
Refer to the manual supplied with your DVD player.
5. Try to operate your DVD player by pressing one
of the above buttons.
• DO NOT forget to turn on the DVD player before pressing one
of the above buttons.
If there are more than one code listed for your brand of DVD
player, try each one until the correct one is entered.
EN26_36.RX-6510VBK[C]_f 01.2.5, 4:26 PM 33