Jensen JIMS-225 - Manual (Page 11)

E10
SETTING AND OPERATION
Video Out
The S-video Out jack allows you to connect this unit to your TV and watch your video files or picture that are
loaded on your iPod photo, 5th generation iPod, 3rd generation iPod nano, iPod classic or iPod touch.
1. Dock the compatable iPod on the unit and make sure the unit is in iPod mode.
2. Connect one end of the S-video cable (not included) to the S-video jack on the back of the unit. Connect
the other end of the cable to the S-video IN jack of your TV or display device.
3. From the main iPod menu, select Videos>Settings>TV Out and select ON.
4. Switch your iPod back to the movie library and play the movie of your choice.
NOTE:For the initial docking of the iPod(3Gen) nano, iPod classic and iPod touch, you
may wait for the finishing of iPod authentication process then the video signal output to
your TV sceen or monitor.
Radio Operation
Important: Prior to listening to the FM radio, fully extend the FM antenna for the
maximum reception.
Radio Tuning
1. Press the POWER button to turn on the unit.
2. Press the FUNCTION button repeatedly until the RADIO icon appears on the LCD display.
3. To tune to a desired station manually, press the or buttons repeatedly until the station is reached.
4. To scan the station automatically, press and hold the or buttons on the unit. It can also be changed
by pressing the or buttons on the remote control.
5. Stereo and mono radio can be selected by pressing the ST / MONO button on the remote control.
6. The volume level can be adjusted by pressing the VOL+/- buttons on the unit or on the remote control.
Preset Station
NOTE:
- Use manual tuning to select weaker stations that might be bypassed during automatic
tuning.
- If the automatic search does not stop at the exact frequency, for example, it stops at
100.9MHz instead of 100.8MHz, press TUN +/- to finely tune the exact frequency.
The unit allows you to store up to 4 preset FM stations in the preset memories for easy recalling any
time.
1. Press the POWER button to turn on the unit.
2. Press the FUNCTION button to select RADIO.
3. Tune to your desire radio station by pressing Tune UP/DOWN buttons.
4. Select a button of P1, P2, P3 or P4 on the remote control.
5. Press and hold the button you want to program until PRESET number icon appears on LCD display. The
station is saved in the preset button now.
6. To store more stations, repeat the steps 4 and 5.