JVC CA-MXJE3 - Manual (Page 6)

4
~
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
For better AM/FM reception
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
Ω
wire with coaxial type
connector (IEC or DIN45325).
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System,
connecting cords, and the AC power cord. This could cause
poor reception.
Ÿ
Digital audio component
• Set “DIGITAL AUDIO OUTPUT” in the “AUDIO”
preference display correctly according to the connected
digital audio equipment (see page 32). If setting is incorrect,
loud noise may be generated causing damage to the
speakers.
!
TV/monitor
• Connect the VIDEO jack or S-VIDEO jack whichever
you want to use.
To set the video output selector
You can select the video output to match it to the color
system of your TV.
Extend it so that you can obtain the best
reception.
AM loop antenna
(supplied)
FM antenna (supplied)
Turn it until the best
reception is obtained.
AM loop antenna (supplied)
Keep it connected.
Vinyl-covered wire (not supplied)
Extend it horizontally.
FM outdoor antenna
(not supplied)
When connecting the auxiliary equipment (AUX)
• The AUX jack is located on the front panel.
NTSC: For an NTSC TV.
PAL: For a PAL TV.
For a multi-color TV, you can
select either one.
OPTICAL
DIGITAL
OUTPUT Protective cap
Composite video
cord (supplied)
S video cord
(not supplied)
AUX
Stereo mini plug cord
(not supplied)