JVC DR-MV5BEK - Manual (Page 39)

Masterpage:Right+
EN
39
Filename [MV5SEK_08Basic TimerDub.fm]
EDITING
Page 39Wednesday, 31 August 2005 19:58
Dubbing An Entire Disc
You can easily use this unit for dubbing without connecting any
other equipment.
1
For DVD deck
Load a disc you want to dub.
For VHS deck
Load a cassette with the record safety tab intact.
2
Press VHS/DVD on the unit repeatedly or VHS on the remote
control so that the VHS lamp lights up on the unit.
3
Press REC MODE repeatedly to set the recording mode.
4
Press }DVD to select the dubbing direction.
● “}” lights up on the unit.
5
Press and hold DUBBING for more than 2 seconds to start the
dubbing.
● If the tape has not been rewound, the VHS deck rewinds the tape
automatically. When the VHS deck has finished rewinding, dubbing
begins automatically.
● After dubbing is completed, the VHS deck rewinds the tape
automatically and the unit shuts off.
● To stop dubbing, press 8.
NOTES:
● When you turn on the unit next time, press }DVD so that “}” lights
off before performing any operations. If it is not done, recording on
the VHS deck is not possible.
● It is not possible to start dubbing if the unit retains a memory of the
resume points. Press 8 twice to clear the resume points.
● There may be a discrepancy of several seconds between where you
intend dubbing to start, and where it actually starts.
● The superimposed indication during the operation or dubbing is not
recorded.
● When the end of the tape is reached during dubbing, dubbing is done
and “[” indicator on the front panel blinks. When pressing x
(EJECT) to eject the tape, “[” indicator on the front panel stops
blinking.
● When the progressive mode is set, “}” does not light up on the unit.
Press PROGRESSIVE SCAN so that video output indicator ( )
lights off on the front display panel.
● It may be impossible to dub a DVD-R or DVD-RW (Video mode) disc
recorded on the devices from other manufacturers or on a PC. In
such case, perform “Manual Dubbing (From DVD To VHS)”
(
੬ pg. 40).
● It is not possible to perform other operations like Live Memory
Playback. Check the recorded programme on the disc after dubbing.
● If “]” lights up on the unit and you play back a DVD VIDEO disc, the
images dubbed to the VHS deck may not be output to the TV
properly.
Disc Dubbing (From DVD To VHS)
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/DVD switch to DVD.
● Make sure that both the DVD deck and the VHS deck are in the
stop mode.
● Set “SUPERIMPOSE” to “OFF”. ( ੬ pg. 79)
PROGRESSIVE
SCAN
VHS
REC MODE
DVD
VHS/DVD
DVD VHS REC
VHS DVD DUBBING
PR
DV IN
STANDBY/ON
S-VIDEO VIDEO AUDIO
VHS/DVD DUBBING
}DVD
MV5SEK_00.book Page 39 Wednesday, August 31, 2005 7:58 PM