Jura Capresso F70 - Manual (Page 10)

10
Ⅲ Place a sufficiently large jug (approx 1 litre) under the replace-
able hot water nozzle (16) and open the steam/hot water tap (14)
(Fig. 12).
Ⅲ
RINSING
FILTER
Ⅲ CLOSE TAP
Ⅲ Open the steam / hot water draw-off tap (14) (Fig. 12).
Ⅲ
HEATING UP
Ⅲ
READY
5.3 Changing the filter without display request
Ⅲ Press the Rotary Switch (1) until
FILTER
ߛ appears.
Ⅲ Press the Rotary Switch (1) to confirm.
Ⅲ
YES ߛ
Ⅲ Press the Rotary Switch (1) again to confirm.
Ⅲ
INSERT/OPEN TAP
Ⅲ The program “Change filter” is now active. Now proceed as
described in Chapter 5.2 from REPLACE/OPEN
TAP onwards.
6. Rinsing the IMPRESSA
When the IMPRESSA is switched off and has cooled down,
a rinsing operation is started when the machine is switched
on again. When the machine is switched off, a rinsing
operation is started automatically.
Ⅲ Touch the
symbol (3).
Ⅲ
HEATING UP
Ⅲ PRESS
MAINT.
Ⅲ Touch the
symbol (7).
Ⅲ
RINSING
Ⅲ
READY
6.1 Rinsing the IMPRESSA without display request
Ⅲ Press the Rotary Switch (1) until
FILTER – /
ߛ appears.
Ⅲ Turn the Rotary Switch (1) until
MAINTENANCE appears.
Ⅲ Press the Rotary Switch (1) to confirm.
Ⅲ
RINSE
Ⅲ Press the Rotary Switch (1) again to confirm.
Ⅲ
RINSING
Ⅲ
READY
7. Adjusting the water quantity for coffee
The indicated value in ML is a reference value and may
deviate from the actual value
You can change/stop the water quantity during the draw-off
operation, too. Turn the rotary switch (1) until the required
ML value is displayed.
You can adjust the water quantity in steps of 5 ML using the
Rotary Switch (1).
Ⅲ READY
Ⅲ Turn the Rotary Switch (1) until the required water quantity is
displayed.
Ⅲ For example,
120 ML