Maintenance, English, Ipod® or d. player operations – JVC KD-G720 User Manual
Page 56: How to clean the connectors, Moisture condensation, How to handle discs

26
ENGLISH
iPod® or D. player operations
• When you turn on this unit, the iPod or
D. player is charged through this unit.
• While the iPod or D. player is connected, all
operations from the iPod or D. player are
disabled. Perform all operations from this
unit.
• The text information may not be displayed
correctly.
– Some characters such as accented letters
cannot be shown correctly on the display.
– Depends on the condition of
communication between the iPod or
D. player and the unit.
• If the text information includes more than
8 characters, it scrolls on the display (see
also page 15). This unit can display up to 40
characters.
Notice:
When operating an iPod or a D. player, english/car/support/ks-pd100/index.html> For D. player users: english/car/support/ks-pd500/index.html> Maintenance How to clean the connectors Frequent detachment will deteriorate the Moisture condensation Moisture may condense on the lens inside the How to handle discs When removing a disc from edges. Do not touch its recording surface. When storing a disc into its case, gently insert use. To keep discs clean A dirty disc may not play correctly. conventional record cleaner, spray, thinner, To play new discs New discs may have some rough Connector Center holder EN26-31_KD-AR770[J]3.indd 26 EN26-31_KD-AR770[J]3.indd 26 11/29/05 5:01:38 PM 11/29/05 5:01:38 PM
some operations may not be performed
correctly or as intended. In this case, visit the
following JVC web site:
For iPod users:
connectors.
To minimize this possibility, periodically wipe
the connectors with a cotton swab or cloth
moistened with alcohol, being careful not to
damage the connectors.
CD player in the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the CD player may
malfunction. In this case, eject the disc and
leave the unit turned on for a few hours until
the moisture evaporates.
its case, press down the center
holder of the case and lift the
disc out, holding it by the edges.
• Always hold the disc by the
the disc around the center holder (with the
printed surface facing up).
• Make sure to store discs into the cases after
If a disc does become dirty, wipe it
with a soft cloth in a straight line
from center to edge.
• Do not use any solvent (for example,
benzine, etc.) to clean discs.
spots around the inner and outer
edges. If such a disc is used, this
unit may reject the disc.
To remove these rough spots, rub the edges
with a pencil or ball-point pen, etc.