JBL VRX932LA User Manual

Page 9

Dual VRX932LA

Unlike most conventional speakers, the VRX932LA is designed so that a pair of speak-
ers may be safely mounted onto a pole or tripod stand. For most applications, the for-
ward socket of the dual angle pole socket will be used. This will tilt the lower of the two
speakers at a 15° down-angle (providing coverage of the near listeners) while the upper
speaker will face straight out (covering the more distant areas). Ideally, the listeners
should not be able to see either the bottom or the top surfaces of the two-speaker array.
Usually, the Array Configuration Selector (ACS) switches on the lower speaker's input
panel should be set to the "Short Throw (-3 dB)" position while the upper speaker will be
set to either "Short Throw (-3 dB)" or "Mid Throw (0 dB)".

Place the speakers on the pole or tripod one at a time. Be sure to lock the two speakers
together using the integral rigging hardware (see below). System illustration shows avail-
able JBL SS4BK speaker pole and SRX718S subwoofers. Do not stack more than two
VRX932LA speakers on a pole.

Locking (2) VRX932LA Loudspeakers Together

Any time two or more VRX932LAs are arrayed together, they must be mechanically secured to each other using
the integral rigging frame and supplied quick release pins. See the diagram below for details. WARNING: Only
the correct quick release pins supplied by JBL are to be used