How to attach the shoulder strap, Power, Charging the battery pack – JVC GR-D239 User Manual
Page 11: Pg. 11), Pg. 11
EN
11
GETTING STARTED
MasterPage: Start_Right
How To Attach The Shoulder Strap
Follow the illustration.
1
Thread the strap through the eyelet.
2
Fold it back and thread it through the strap
guide and the buckle.
● To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3
Slide the strap guide fully towards the eyelet.
This camcorder’s 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
1
Set the Power Switch to “OFF”.
2
With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount
a.
3
Slide down the battery pack until it locks in
place
b.
4
Connect the AC Adapter to the camcorder.
5
Connect the Power Cord to the AC Adapter.
(AP-V14E only)
6
Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
7
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
1
2
2
3
Strap guide
Buckle
Eyelet
Power
POWER/
CHARGE
M
A
POWER/CHARGE lamp
Battery pack
PUSH BATT.
Open the cover.
Power switch
mark
Arrow
Battery pack mount
To DC connector
To AC outlet
AC Adapter (ex. AP-V17E
)
CONTINUED ON NEXT PAGE
GR-D239PAL_04Start.fm Page 11 Tuesday, May 10, 2005 9:09 AM