Jet Tools M-708640 - Manual (Page 9)

9
7. Thread a M6 hex nut onto the filter bag
support rod, follwed by a M6 flat washer and
M6 lock washer (A, Fig. 5). Thread the
support rod (B, Fig. 5) into the motor/fan
housing and tighten nut against housing.
8. Place the retaining strap (C, Fig. 5) through
the loops on the filter bag and hang the filter
bag from the hook.
9. Secure bag to housing with retaining strap.
Note: The retainer strap should be tight
enough to provide a good seal.
10. Insert the snap ring of collector bag into the
bottom of housing at an angle, see Figure 6.
11. Pull down on the ring and bag to make sure
it “seats” in the housing.
Note: make sure the snap ring “snaps” into
place in the housing.
Cleaning the Filter Bag
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
During first use and after cleaning, the filter bag
may allow some dust to escape. This is normal
and will stop after a short period of time.
Clean both the filter and collector bags
frequently to keep the collector's performance at
its optimum. To clean:
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
1. Disconnect the machine from the power
source.
2. Unhook the filter bag from the hanger and
shake the bag so that the majority of the
dust falls into the collector bag.
3. Loosen the retaining strap, and remove the
filter bag from the housing.
4. Turn the bag inside out and clean.
5. Turn the bag outside in and re-attach to the
housing using the retainer strap to secure.