JVC LVT2101-001A - Manual (Page 19)

19
Installation and
Setup
[LOCK] Menu (Parental Control)
Use the v / V / b / B buttons to select [LOCK] set-
tings in the [Setup] menu.
The [LOCK] settings affect only BD and DVD play-
back. Set the password and have to input it to vali-
date the [LOCK] settings.
Password
You can create, change or delete the password.
1. Select [Password] option on the [LOCK] menu
then press B.
2. Use number buttons on the remote control to
input the 4-digit password.
To create new password, press ENTER when the
[New] option is highlighted. Input new password
and press ENTER. Enter it again and press
ENTER to verify.
To change the password, press ENTER when the
[Change] option is highlighted, then input old
password and press ENTER. Input new password
and press ENTER. Enter it again and press
ENTER to verify.
To delete the password, select [Delete] option
then press ENTER, then input password and
press ENTER. The password is deleted.
Tip:
If you make a mistake before pressing ENTER,
press CLEAR or b
b to delete a number one by one.
If you forget your password
If you forget your password, you can clear it using
the following steps:
1. Remove any disc that might be in the player.
2. Select [LOCK] t [Password] option in the
[Setup] menu.
3. Use Number buttons to enter the 6-digit number
“210499”.
The password is cleared.
DVD Rating
Blocks playback of rated disc based on their con-
tent. (Not all discs are rated.)
1. Select [DVD Rating] on the [LOCK] menu then
press B.
2. To access this option, you must input the pass-
word you have created. If you have not yet
entered password, you will be prompted to do so.
Input a password and press ENTER. Enter it
again and press ENTER to verify. If you make a
mistake before pressing ENTER, press CLEAR or
b
b to delete a number one by one.
3. Select a rating from 1 to 8 using the v / V but-
tons.
[Rating 1-8] – Rating one (1) has the most
restrictions and rating eight (8) is the least
restrictive.
[Unlock] – If you select unlock, parental control
is not active and the disc plays in full.
4. Press ENTER to confirm your rating selection.
BD Rating
Set an age limit for BD-ROM viewing.
1. Select [BD Rating] on the [LOCK] menu then
press B.
2. Follow step 2 as shown above (DVD Rating).
3. Use number buttons to input an age limit for
BD-ROM viewing.
[255 Year(s)] – All BD-ROM can be played.
[0-254 Year(s)] – Prohibits play of BD-ROM with
corresponding ratings recorded on them.
4. Press ENTER to confirm your selection.
Area Code
Enter the code of the area whose standards were
used to rate the DVD video disc, based on the list
on page 29.
1. Select [Area Code] on the [LOCK] menu then
press B.
2. Follow step 2 as shown above (DVD Rating).
3. Select an area code using v / V buttons then
press ENTER to confirm your selection.
BD
DVD
BD320-JN_BUSAJJK_OM_ENG 8/31/09 12:16 PM Page 19