Select the desired options, Select the “delay start, Start the programme – John Lewis JLWD 1408 User Manual
Page 17: How to interrupt a programme
17
The relevant light will light up.
7. Select the desired options
If your laundry is very dirty, it may be advisable to
select the “Prewash” option.
If your laundry is only slightly soiled, select the
“Quick” option.
If you wish the laundry to undergo an extra rinse,
select the “Extra Rinse” option.
The relevant light illuminates.
8. Select the “Delay start”
Before you start the programme, if you wish the
start to be delayed, press the Delay start button
repeatedly, or keep it pressed, to select the desired
delay. The selected delay time value (up to 23 hours)
will appear on the display for 3 seconds, then the
duration of the programme will appear again.
During this period it is possible to load other laundry:
press the “Start/Pause” button. Open the door. Load
the laundry. Close the door and press the
“Start/Pause” button again.
Delay
start
Prewash Quick
Extra
rinse
1400
900
700
500
Rinse
hold
Spin
9. Start the programme
Press the “Start/Pause” button. The relevant light will
stop flashing, and only the light relevant to the phase
that is in progress will remain lit. The machine starts
operating.
If you have chosen a delayed start, the washer dryer
will begin the countdown.
The display will show the duration of the programme
or the selected delay.
10. How to change an option
or a programme during its
cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
machine by pressing the “Start/Pause” button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then
to the new programme position.
Start the new programme by depressing the
“Start/Pause” button. The washing water in the tub
will not emptied out.
11. How to interrupt a
programme
Depress the “Start/Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
12. How to open the door
during the cycle of a
programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the machine is not in the heating phase beyond 55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washer dryer, the door locked light goes off and the
door can be opened.