GE RM24948 - Manual (Page 3)

5 4
1. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
2. Press and release the desired device
button (TV, VCR, etc.). The red indicator
blinks, then stays lit.
3. Enter the 4 digit code for
your brand of TV, VCR,
etc., from the Library Code
Table by using the Rewind,
Play, and Fast Forward
buttons.
Use the REW button to enter the first digit.
CHANNEL Up/Down
Changes the channels.
Also controls DVD SKIP
functions.
POWER Turns
product On or Off.
VOLUME UP/DOWN
Changes the volume
level of the product,
normally the TV.
SETUP Used to setup
the remote, and for
code search function.
MUTE Turns off the
TV sound, while the
picture remains.
TV, CBL/AUX, VCR/DVD
Selects product to be
operated.
Red Indicator
Lights when any
button is pressed.
Note: The REC button must be pressed TWICE to
record from your VCR. For some brands of VCRs, you
might need to press the REC button once, then press it
again for three seconds.
RECORD, PLAY, STOP,
REW, FF, PAUSE VCR/DVD
control buttons operate
your VCR or DVD even
when the remote is set to
operate the TV.
Button Functions Code Entry using the Code List
Use the Play button to enter second digit.
Use the FF button to enter the third digit.
For Example: To enter code 013, don’t press REW,
press Play once, and FF three times. The red LED
blinks off with each keypress.
4. Press the Stop button to save the code.
Note: for a valid code, the red LED turns off. For an
invalid code, the red LED blinks rapidly for three
seconds before going off.
5. With your device on, press POWER. If the
device turns off, no further programming is
required. Note: If some buttons do not operate
your equipment, try one of the other codes for
your brand.