JVC NX-CDR7 - Manual (Page 14)

– 11 –
English
3CD
DIGITAL OUT
• When connecting a digital component equipped with
an optical digital input terminal
You can record playback sounds of 3-CD Changer onto
the other component—digital-to-digital recording.
Protective cap
Before connecting the other component,
remove the protective cap from the terminal.
To optical digital
input
Audio equipment with
optical digital input
Connect between the optical digital input terminal on the
other component and the 3CD DIGITAL OUT terminal.
NOW, you can plug in the unit and other connected
components FINALLY!
To a wall outlet
SPEAKERS
CAUTION :
SPEAKER IMPEDANCE
6 16
R L
R L
FM
COAXIAL
LINE IN
LINE OUT
3CD
DIGITAL OUT
LINE
DIGITAL IN
R L
R L
AM
LOOP
(75 )
ANTENNA
OPTICAL
AM EXT
To connect digital components
• When connecting a digital component equipped with
an optical digital output terminal
The following connection allows you to perform digital-
to-digital recording (through the digital terminals) and
playback of the connected digital component (through
the analog terminals.)
By using an optical digital cord (not supplied) and an audio
cord (not supplied), connect:
• Between the optical digital output terminal on the other
component and the LINE DIGITAL IN terminal.
• Between the audio output jacks on the other component
and the LINE IN jacks. (This connection is required to
play back sounds through this unit when the source is
“LINE.”)
SPEAKERS
CAUTION :
SPEAKER IMPEDANCE
6 16
R L
R L
FM
COAXIAL
LINE IN
LINE OUT
3CD
DIGITAL OUT
LINE
DIGITAL IN
R L
R L
AM
LOOP
(75 )
ANTENNA
OPTICAL
AM
EXT
To optical digital output
Protective cap
Before connecting the
other component,
remove the protective
cap from the terminal.
Audio component with
optical digital output
To output (PLAY)
The digital connection through the LINE DIGITAL
IN terminal can be only used for recording.
• When connecting a digital component to this unit,
always connect it both to the LINE DIGITAL IN
terminal and the LINE IN jacks.
EN01-12_NX-CDR7[J_C]_4 01.9.14, 3:41 PM 11