Jensen PS260 - Manual (Page 7)

PS260 / PS285 / PS2130 / PS2180
7
4 ohm nominal
2 ohm minimum
4 ohm nominal
2 ohm minimum 4 ohm minimum
C
L
L C
Inductor Capacitor
Wiring (continued)
Speaker Wiring
The Speaker Wiring diagrams illustrate the following four options for connecting speakers and
subwoofers to the PS amps:
• Two Speakers
• Two Subwoofers
• Bridged Subwoofer
• Tri-Mode
Note: When running a subwoofer and two full-range speakers together (tri-mode
operation), passive high and low pass filters must be used. Failure to install these filters
may cause damage to the amplifier and/or the speakers.
Two Speakers
Dos Altavoces
Deux Haut-Parleurs
Two Subwoofers
Dos Subwoofers
Deux Subwoofers
Bridged Subwoofer
Subwoofer en Puente
Subwoofer En Pont
Tri-Mode
Tri-Modoa
Tri-Mode
Passive High and Low Pass Filter Chart
Frequency
Hz.
Speaker Impedance
2 Ohms 4 Ohms 8 Ohms
Inductor (L) Capacitor (C) Inductor (L) Capacitor (C) Inductor (L) Capacitor (C)
80 4.1mH 1000 µF 8.2mH 500µF 15mH 250µF
100 3.1mH 800 µF 6.2mH 400 µF 12mH 200 µF
130 2.4mH 600 µF 4.7mH 300 µF 10mH 150 µF
200 1.6mH 400 µF 3.3mH 200 µF 6.8mH 100 µF
250 1.2mH 300 µF 2.4mH 150 µF 4.7mH 75 µF
400 0.8mH 200 µF 1.6mH 100 µF 3.3mH 50 µF
600 0.5mH 136 µF 1.0mH 68 µF 2.0mH 33 µF
800 0.41mH 100 µF 0.82mH 50 µF 1.6mH 26 µF
1000 0.31mH 78 µF 0.62mH 39 µF 1.2mH 20 µF
1200 0.25mH 66 µF 0.51mH 33 µF 1.0mH 16 µF
1800 0.16mH 44 µF 0.33mH 22 µF 0.68mH 10 µF
4000 0.08mH 22 µF 0.16mH 10 µF 0.33mH 5 µF