Jwin JT-P870 - Manual (Page 6)

12/19/2003 8:34 AM 6
4. Then the telephone will display ‘Set Hour’.
5. Use steps 2 - 3 to set the hour.
6. Finally the telephone will display ‘Set Minute’.
7. Use steps 2 – 3 to set the minutes.
8. After the settings are complete, press the [TIME] button once and the telephone will
announce the time.
Note: If you don’t press any keys within 8 seconds after entering the time setting, the
telephone will exit setting mode automatically.
LCD Contrast
After the Time/Date Setting, you will be prompted to enter the LCD Contrast Setting:
1. Press the [UP] and [DOWN] buttons to adjust the LCD contrast. There are eight levels
for contrast adjustment.
2. Press [DEL] to confirm and exit settings.
Ringer HI / LO / OFF Selection
To adjust the volume of your ringer on your phone:
1. Slide the [RINGER] switch to ‘HI’ position or ‘LO’ position according to your
preference.
2. Slide the [RINGER] switch to the ‘OFF’ position to turn the ringer off. The ringer will
not be activated by any incoming calls.
Tone / Pulse Selection
Select the dialing mode that your telephone requires by sliding the [T-P] switch to either:
‚ ‘T’ position for tone dialing, or to
‚ ‘P’ position for pulse dial.
Note: While in pulse dial status, press ‘ ＊’ to change to tone dial.
Speakerphone and Receiver Volume Adjustment
These volume switches are located on the sides of the phone base. The receiver volume is
on the left and the speaker volume switch is on the right.
- Pick up the receiver and slide the [VOLUME] switch to adjust the receiver volume.
- The switch slides from MIN (lowest volume) to MAX. (highest volume). Adjust
according to your preference or need.
Answer (Recording) On / Off Setting
- The default Answer (recording) state is ‘On’, Press [ANSWER] once and the
telephone will display ‘Answer Off’.
- Press [Answer] again; the telephone will display ‘Answer On’.
Note: