Jwin JT-P870 - Manual (Page 11)

12/19/2003 8:34 AM 11
Recover all messages (immediately after erasing):
- Again, depress [ERASE] for about 2 seconds. All erased messages will be recovered
after a long “beep”.
Note: If there is no message in record, then there will be two short “beeps” to indicate that
no message has been erased.
Note: If any recording action is performed after all messages have been erased, the
deleted messages cannot be recovered.
Remote Control
- After you hear the out going message, input the security code (Please refer to Setting
the Remote Security Code). You will hear a long beep.
- Enter any of the following functions by pressing the appropriate key:
Remote-Control Key Function and Description
Key(s) Function
＊ Skip OGM1 play
1 Play OGM1
2 Room Monitor (up to 15 seconds)
3 Play Memos (press twice to play previous message)
4 Play all incoming messages or press again to pause
5 Play New Messages (When playing Incoming Messages or
MEMO recordings, press this key to play the next message.)
6 Erase Individual Message
7 Stop Play
＊1
Record OGM1
＊2 Record a MEMO
＊3
Change Security Code
＊4 Erase all messages
＊5 Switch from Answer “On” Mode to Answer “Off” Mode
# Exit Remote Control
Room Monitor
While in remote control mode, the user can monitor the room of the telephone by entering the
corresponding key(s). The room may be monitored for 15 seconds.
Procedure:
- Use another telephone to dial your telephone number.
- Input the security code to enter the remote control menu.
- Press [2] to enter room monitor mode.