beautypg.com

Controls and connectors – JBL P-4020 User Manual

Page 3

background image

3

• Always wear protective eyewear when

using tools.

• When routing cables, keep input signal

cables away from power cables and
speaker wires.

• When making connections, make sure

that each connection is clean, insulated
and properly secured. Observe the
polarity markings on the rear panel.
Refer to the application drawings to set
up the amplifier for operation in stereo,
bridged-mono, bi-amp or tri-mode con-
figurations.

• If the amplifier’s fuse must be replaced,

use only the same rating and type as a
replacement. Do not substitute another
kind.

Controls and Connectors

1. Pre-amp Level Input Connector –

Connects to line-level output from the
source unit.

2. Universal Interface Speaker-Level

Connector – Connects to speaker-level
output from the source unit. Provides
Common Sense amplifier turn-on
when used with factory radios
(2-channel on P-4020, 4-channel on
P-4040).

3. Pre-amp Level Output Connector –

Connects to other amps or processors
in the signal chain (flat on P-4020, flat
or filtered on P-4040).

4. Speaker-Output Connector – (2-chan-

nel on P-4020, 4-channel on P-4040).

5. Fuses – P-4020: 20A ATC type, P-4040:

30A ATC type.

6. Power Connector – Connection for

12V +, Gnd and Rem.

7. Input-Mode Switch – Sums left and

right inputs.

8. Input-Sensitivity Control – Adjusts

input sensitivity for pre-amp level and
speaker-level inputs.

9. Pre-amp Output Selector Switch –

Selects input path for pre-amp output.
Output can be summed from front and
rear inputs with no filter, or filtered by
the front or rear crossover.

10. Rear-Channel Input Selector – Selects

rear-channel input between front input
and rear input.

11. Crossover Selector – Determines

whether the crossover is a High-Pass
filter (HP), a Low-Pass filter (LP) or
unfiltered (Flat).

LEVEL

INPUT MODE

MO ST

4V

.250V

XOVER

FLAT

HP

LP

2V

20

R

+

L

+

+BATT

REM

GND

BRIDGE

SPEAKER OUTPUTS

POWER

FUSE

20A

MADE IN THE U.S.A.

R

L

LINE LEVEL

INPUT

SPEAKER LEVEL IN

R

+

L

+

AUX

OUT

R

L

+ R –

+ R –

– L +

– L +

AUX
OUT

R

L

R

L

FRONT

FRONT

REAR

LINE LEVEL

INPUT

SPKR LEVEL IN

REAR

ST MO

INPUT MODE

PRE OUT

LEVEL

INPUT MODE

MO ST

4V

.250V

FRONT

F+R

FLAT

REAR

LP

FRT
LP

FRT

REAR

XOVER

FLAT HP LP

XOVER

FLAT

HP

LP

LEVEL

4V

.250V

2V

2V

REAR

INPUT

F U S E

3 0 A

B R I D G E

– R +

– L +

MADE IN THE U.S.A.

+BATT

REM

GND

BRIDGE

SPEAKER OUTPUTS

POWER

FRONT

REAR

30

8

7

11

5

4

6

1

2

3

1

2

3

9

10

8

7

11

8

11

4

5

6

P-4020

P-4040

7

P-4020/4040 OM. 7/14/98 11:42 AM Page 3

This manual is related to the following products: