JVC HR-J255EE - Manual (Page 4)

4
EN
1 2 3
4 5 6
7 8 9
0
2
4
1
3
Video
Channel Set
INITIAL SETTINGS
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
If you have connected the video recorder to your TV
via the provided RF cable only (RF connection) – Go to
"With RF Connection" below.
If you have connected the video recorder to your TV
via both the provided RF cable and an AV cable (AV
connection) – Go to "With AV Connection" on next
page.
ACCESS VIDEO CHANNEL
SET MODE
1
Hold down STOP/EJECT on the recorder until the
display panel shows the following.
SELECT TV SYSTEM
2
Press TV PROG + or – to set appropriate TV system that
matches the system of TV being used (refer to the table
below).
TEST SIGNAL
The channel on which the screen to
the left appear clearly in step 3 is
your Video Channel.
To view picture signals from the video recorder, set
your TV to the Video Channel.
IMPORTANT:
Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.
With RF Connection
1 : B/G 2 : D/K 3 : I
STOP/EJECT
TV PROG+/–
TV PROG+/–
Major Countries TV System
Austria, Denmark, Finland,
Holland, Italy, Norway, Spain,
Switzerland, Sweden,
B/G
Germany, Egypt
China, Mongolia, Rumania,
Bulgaria, Czech Rep., Slovakia,
D/K
Hungary, Poland, Russia
Hong Kong I
OK