Select the delay start, Start the programme, How to interrupt a programme – John Lewis JLWM1405 User Manual
Page 18: End of programme
18
7. Select the Delay start
The delay starting of a programme, press repeatedly
the “Delay Start” button to select the desired delay.
The figures corresponding to the selected delay will be
displayed for about 5 seconds.
8. Start the programme
To start the selected programme, press the “Start/
Pause” button; the corresponding light stops flashing
and stays on. The machine starts operating.
The door locked light illuminates to indicate that the
door is blocked.
If you have selected the delay start the machine starts
its countdown. The display shows the delay and the
duration of the programme.
During this period it is possible to load other laundry:
• depress “Start/ Pause” button, the door locked light
goes off.
• load the laundry.
• close the door and depress “Start/ Pause” button
again.
9. How to change an option or
a programme during its cycle
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “Start/ Pause” button.
Changing a running programme is possible only by
resetting it.
Turn the programme selector dial to “Off” and then to
the new programme position. The washing water in the
tub will not emptied out. Start the new programme by
depressing the “Start /Pause” button.
1400
Start in 30 min
h min
2.23
10. How to Interrupt a
programme
Depress the “Start / Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
11. How to open the door
during the cycle of a
programme
You can open the door, after having set the washing
machine to Pause, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
If these requirements are met, when you pause the
washing machine, the door locked light goes off and the
door can be opened.
Should it not be possible to open the door, and should
it be absolutely necessary to do so, switch the machine
off by turning the selector dial to “Off”.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of
the water in the washing machine!
When you close the door to restart the programme
turn the dial to the previous programme repeating the
options previously selected and press “Start/ Pause”
button.
12. End of programme
The machine stops automatically. The light of the “Start
/ Pause” button goes out, the display shows
alternatively the messages «Door openable» and«Cycle
ended» and some acoustic signals are given.
Turn the programme selector dial to Reset “Off” to
switch the machine off.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
john_lewis_rev4.qxp 9/15/2006 4:39 PM Page 18