John Lewis JLWM1405 - Manual (Page 14)

14
Option selection
Depending on the programme, different functions can
be combined. These must be selected after choosing
the desired programme and before depressing the
“Start/ Pause” button.
When you press an option button, (for ex. the
Prewash ) the corresponding light illuminates and, on
the display, appears the description of the selected
function.
If you press the same button again, the button light
goes out and the display shows that this option has
been deactivated.
Washing phases
During the washing cycle, the display will show the
different washing phases.
Delayed start
The selected delay (20 hours max) set by means
of the relevant button appears on the display for
5 seconds, then the selected programme
displays.Press the Start/ Pause button to start the
delay start.
1400 Spinning
h min
2.05 1400 Washing
h min
2.05
1400 Prewash No
h min
2.19 1400 Prewash Yes
h min
2.54
0 No spin
h min
2.23
The countdown is updated every hour and for the
last 2 hours, every 30 minutes.
Incorrect option selection
If an option which is not compatible with the set
wash programme is selected, the message
«Selection error» is displayed for about 3
seconds.
Alarm messages
In the event of operating problems, some
corresponding messages are displayed (for more
information see paragraph “Something not working”
at page 25).
Some of these problems are due to an incorrect use
of your washing machine and are easy to resolve.
End of programme
When the programme has finished (when the water
has emptied out) and the light of the “Start/ Pause”
button and the door locked light go out, then the
door can be opened and the display will show
alternatively the messages «Door openable» and
«Cycle ended»
.
1400 No Incoming water
h min
2.23
1400 Selection error
h min
2.23
1400 Start in 30 min
h min
2.23
john_lewis_rev4.qxp 9/15/2006 4:39 PM Page 14