JVC UX-P7 - Manual (Page 18)

– 16 –
Recording
Recording on a Tape
On the unit ONLY:
1
Put a recordable cassette in with the exposed
part of the tape down.
2
Close the cassette holder gently.
• If you want to record on both sides of a tape, see “To
record on both sides — Reverse Mode.”
3
Check the recording direction for the tape.
• If the tape direction is not correct, press TAPE 2 3
twice then
7 to change the tape direction.
4
Start playing the source — FM, AM or
auxiliary equipment connected to AUX jacks.
• When the source is CD, see “CD Direct Recording” on
page 17.
5
Press REC.
The REC indicator lights up on the display and
recording starts.
The REC lamp on the unit also lights red.
To stop recording, press 7.
To remove the cassette, press 0 for cassette deck.
To record on both sides — Reverse Mode
Press REV.MODE on the unit until the
indicator is lit.
• When using the reverse mode for recording,
start recording in the forward (
3) direction first.
Otherwise, recording will stop when recording is done only
on one side (reverse) of the tape.
REC
IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, AHB (Active Hyper Bass)
PRO, and SOUND MODE settings. Thus, during recording
you can adjust the sound you are actually listening to
without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
• You can use type I tape for recording.
To protect your recording
Cassettes have two small
tabs on the back to protect
from unexpected erasure or
re-recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
To demagnetize the heads
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).
At the start and end of cassette tapes
There is leader tape which cannot be recorded onto. Thus, when
recording CDs or radio broadcasts, wind the leader tape first to
ensure that the recording will be made without any music part lost.
Heads
Capstans
Pinch rollers
REV.MODE
REC
EN16-22.UX-P7[A] 01.5.9, 11:00 AM 16