Playing back tapes – JVC UX-P7 User Manual
Page 17
– 15 –
Playing Back Tapes
You can play back type I, type II, and type IV tapes without
changing any settings.
Playing Back a Tape
1
Press
0 for cassette deck.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE
2
2
2
2
2 3
3
3
3
3.
The unit automatically turns on and the tape
play starts. The tape direction indicator
(
3 or 2) flashes slowly on the display.
• Each time you press the button, the tape direction
changes.
3
3
3
3
3 : plays the front side.
2
2
2
2
2 : plays the reverse side.
The tape direction lamp on the unit starts flashing to
indicate the tape running direction.
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to or . (See “To
play both sides — Reverse Mode.”)
To stop playing, press
7.
To fast-wind to the left or to the right, press
¢ or 4
while the tape is not running.
The tape direction indicator (
3 or 2) starts flashing quickly
on the display.
To remove the cassette, press
0 for cassette deck.
To play both sides — Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE on the unit.
• Each time you press the button, reverse mode
changes as follows:
:
The deck automatically stops after playing both
sides of the tape. (Stops when playback in the
2 direction is finished.)
:
The deck continues to play both sides of the
tape until
7 is pressed.
:
The deck automatically stops after playing one
side of the tape.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
REV.MODE
TAPE
REC
EN12-15.UX-P7[A]
01.5.9, 10:41 AM
15