JVC RC-EZ38SJ - Manual (Page 22)

18
CASSETTE PLAYBACK
Notes on cassette tapes
• Use only type-I normal tapes. The recording/playback
characteristics of this unit are those for normal tapes,
which have different characteristics from CrO
2
and
metal tapes.
• The use of tapes longer than 120 minutes is not
recommended, since characteristic deterioration may
occur and these tapes easily jam in the pinch roller and
the capstan.
• Loose tape may cause trouble. Gently tighten the tape
with a pencil as shown in the figure below.
• To prevent recordings from being accidentally erased,
remove the tab(s) with a screwdriver. After the tabs
have been broken off, reseal the slots with adhesive
tape to erase or re-record.
Loading a cassette
1 Press § STOP/EJECT to open the cassette
holder.
2 Load a cassette with the open side up and the
playback side facing out as shown in the figure
below.
Forward direction
=
3 Close the cassette holder by pressing it gently and
firmly.
The cassette holder clicks back into position.
Turn the pencil to take up
the slack.
Basic operation
RANDOM
MUTING EQ
1 2 3
4 5 6
7 8
9 0 VOL
REMOTE CONTROL UNIT
TAPE
TUNER/ BAND CD USB
REPEAT
SLEEP
MENU/ FM MODE
STOP/ ENTER
PROGRAM/ PRESET
STANDBY/ ON /
2 1 3 1 4 4
1 Press TAPE to enter the tape mode.
2 Load a cassette.
Use only a type-I normal tape.
3 Press 3 PLAY to start playback.
4 Adjust the volume.
To stop playback
Press § STOP/EJECT.
The tape also stops when it reaches the end.
Fast-winding a tape
Press
1 REW or ¡ FF.
When the tape reaches the end, press
§ STOP/EJECT
to release 1 REW or ¡ FF.
03_01-22_RC-EZ38S.p65 06.6.26, 8:48 PM 18