JVC HR-DD840U - Manual (Page 43)

EN
43
1 2
4 5
3
6
8
0
7 9
CHECK INPUT DATA
4
Press OK and the Program
screen appears.
The PlusCode number you
entered and the matching
Timer-Recording informa-
tion is displayed on the
Program screen. Check to
make sure it’s accurate.
● To timer-record daily or
weekly serials, press DAILY (NUMBER “8”) or
WEEKLY (NUMBER “9”). “DAILY” or “WEEKLY”
appears on the Program screen. Pressing the button
again makes each corresponding display disappear.
● If you made a mistake, press CANCEL and, after
pressing MENU as many times as necessary to access
the VCR Plus+ screen, input the correct PlusCode
number.
● If you are using the Illumi-Guide feature, MENU
lights up for about 10 seconds.
SET TAPE SPEED
5
Press SP/EP.
CHECK/CORRECT INPUT
DATA
6
If the data is correct as it is, go to step 7. If not, press
OK or TIME SCAN ™ £ until the item you want
to change begins to blink. Then press the appropriate
NUMBER keys, CH
5∞ or TIME SCAN5∞ to obtain the
desired setting.
● If you are using a DBS receiver, the BAND indication
(TV or CATV or DBS) appears at right of the channel
number display when OK or TIME SCAN ™ £
is pressed. See "ATTENTION FOR DBS RECEIVER
USERS" on page 45.
RETURN TO NORMAL
SCREEN
7
Press MENU as many times as necessary.
● Press just once to access the Auto Timer screen
(
੬
pg. 47).
ENGAGE TIMER MODE
8
Press TIMER. The VCR turns off automatically.
NOTES:
● To disengage the timer before recording starts, press TIMER
again. Pressing once more re-engages it.
● In case of a power failure after programming, the VCR’s
memory backup keeps your selections for approximately
10 minutes.
● When timer-recording cable channels received through a
Cable Box, be sure to keep the Cable Box set to ON.
PROGRAM 1
(VCR PLUS+ 12345678)
DATE 12/24 WED
START 12:00 PM
STOP 1:00 PM
CHANNEL 40 SP
PRESS (8=DAILY, 9=WEEKLY
SP/EP=REC SPEED)
PRESS (MENU) TO END
NUMBER
TIMER
CH
OK
MENU
TIME SCAN
SP/EP
NUMBER "9"
CANCEL
NUMBER "8"