JBL SCSSAT300 - Manual (Page 6)

6
Connect each speaker to
the corresponding speaker
terminals on your receiver
or amplifier.
If you are using a subwoofer,
follow the directions in that
owner’s guide to connect
and configure it.
Configure your receiver or
processor to reflect the cor-
rect number of speakers in
your system. If you have
added one SCSSAT300/200
speaker to a 5.1-channel
system, reconfigure it as
a 6.1 system. If you have
added two SCSSAT300/200
speakers to a 5.1-channel
system, reconfigure it as
a 7.1 system. The SCSSAT300/200 should
be set to “Small.” If your
receiver allows you to set
the crossover frequency
between the subwoofer and
the speakers, select 100Hz or
the setting that is the closest
frequency below it.
SYSTEM CONNECTION
– +
– +
– +
– +
– +
– + – +
– + – +
Receiver
Subwoofer
Out
Left
Front
Left
Surround
– +
Right
Front
Right
Surround
Subwoofer
Center
Surround Back
Left
– +
Surround Back
Right
LFE In
Right Surround
Right Front
Left Surround
Left Front Center
– +
Surround Back
Left
– +
– +
Surround Back
Right
SCS-SAT300/200 OM 5/24/06 12:41 PM Page 8