JBL SCSSAT300 User Manual

Page 4

Important Safety Note: The
customer is solely responsi-
ble for proper selection of
mounting hardware not
included with the speaker,
and for proper assembly
and installation of the wall
bracket, including but not
limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware
and/or bracket installation.
Be sure to follow these
bracket assembly and
installation instructions
carefully. If you have any
questions or doubts about
your ability to correctly wall-
mount the speakers, consult
with your authorized JBL
dealer or custom installer.

Step 1: Unscrew and remove
the large Molded Nut ™. If
necessary, use the supplied
Metal Bar ∞ as a lever by
inserting it into one of the
holes in the outer edge of
the Molded Nut ™.

Step 2: Firmly grasp the Ball
and Shaft £ and pull it
straight out of the Attach-
ment Plate ¢. Avoid leaning
it to the side for leverage, as
this may break off a tab.

Step 3: Slide the Molded Nut
™ onto the Ball and Shaft
£ with the threaded open-
ing facing the ball. Thread
the Metal Nut ¡ all the way
onto the Ball and Shaft £,

with the star washer side
away from the ball. Refer to
the exploded drawing for the
proper orientation of these
parts.

Step 4: Screw the Ball and
Shaft £ into the Threaded
Insert § on the back of the
Satellite Speaker ¶ until
it is fully seated in the
Threaded Insert §, but
do not tighten, as you might
dislodge the Threaded Insert
§. Such damage would
not be covered under the
warranty.

Step 5: Tighten the Metal Nut
¡ with the star washer side

between the Metal Nut ¡
and the back of the Satellite
Speaker ¶, using large
needle-nose pliers until it is
firmly seated against the back
of the Speaker ¶ and has
locked the Ball and Shaft £
and the Speaker ¶ together.
Note that once the Metal Nut
¡ is fully tightened, it may
embed some marks on the
back of the Satellite Speaker
¶. However, these marks
will be covered by the Metal
Nut ¡.

Step 6: Mount the Attach-
ment Plate ¢ into a wood

stud on the wall, using four
#10 pan-head wood screws
at least one inch long (not
supplied) •. Make sure that
all four screws are driven
into the stud and not into
drywall. If the bracket needs
to be mounted in drywall,
the customer is responsible
for selecting and using
appropriate wall anchors
and screws.

Important Note: The Metal
Nut ¡ must be fully tight-
ened against the Satellite
Speaker ¶ as described in
Step 5 before beginning Step
7 in order to avoid damage
to the Threaded Insert §.

WALL-MOUNTING

SCS-SAT300/200 OM 5/24/06 12:41 PM Page 6