JVC HR-DD848E - Manual (Page 31)

EN
31
ENTER CHANNEL POSITION
6
Press TV PROG +/–.
IMPORTANT
Be sure to confirm the setting of PDC/VPS recording.
● If " ON" is displayed on the screen or " " is lit
on the display panel, PDC/VPS is set to ON.
● If " OFF" is displayed on the screen or " " is
not lit on the display panel, PDC/VPS is set to OFF.
To change the setting, press : PDC/VPS
(NUMBER key "7").
੬
"PDC/VPS Recording" on page 33.
SET TAPE SPEED
7
Press SP/LP ( ) to set the tape speed.
RETURN TO NORMAL SCREEN
8
After confirming all information is correct, press OK
and the normal screen appears.
● Repeat steps 1–8 for each additional programme.
ENGAGE RECORDER’S TIMER
MODE
9
Press TIMER. The recorder turns off automatically.
To Timer-Record Weekly Or Daily Serials . . .
. . . anytime during steps 2 through 8, press WEEKLY (NUMBER
key “9”) for weekly serials or DAILY (NUMBER key “8”) for
daily serials (Monday–Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
q
SLOW SLO W
1 2
4 5
3
6
8
0
7 9
2
4
1
3
DAILY
OK
WEEKLY
TIMER
SP/LP
:PDC/VPS
SP
– P1 –
START STOP
21:00 = 22:00
SP ON
DATE TV PROG
25.12 1
ARD 1
[+/–] =
[MENU] : EXIT
NOTES:
● To timer-record a satellite broadcast through a satellite tuner
connected to the AV2 IN/DECODER connector on the back of
the recorder, in step 6 above, set "TV PROG" to "AUX2" by
pressing TV PROG +/–. Before the selected programme
begins, select the appropriate channel on the satellite tuner,
then set the tuner's timer. If your satellite tuner doesn't have a
timer, leave the unit's power switched on.
● You can programme this recorder to timer-record as many as
8 programmes. If you try to programme the recorder to record
a ninth, "PROGRAM FULL" appears on screen and "FULL"
appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes (
੬
pg. 32).
TIMER
TV PROG