JVC HR-DD848E - Manual (Page 19)

EN
19
Names of
special-effects
playback
Reverse Forward
Search Play Slow-Motion *Still Slow-Motion Play Search
-9x -7x -5x -3x -1x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 3x 5x 7x 9x
-7x -3x -1/6x -1/18x 0 1/18x 1/6x 1x 2x 5x 9x
Audio is output.
Audio is not Audio is Audio is not
Audio is output.
output. output. output.
TimeScan
Speed LP
Speed SP
Audio output
* Still mode cannot be engaged using the remote control's PUSH JOG button.
● The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
● To resume normal playback, press PLAY.
● When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change depending on how far it is turned.
● Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
● The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
● Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
● Picture may appear distorted in comparison to normal playback.
● In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
● TimeScan sound quality will differ in comparison to normal playback.
● When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
● TimeScan does not work with NTSC playback. Picture will be monochrome with an LP-recorded MESECAM tape during
TimeScan.
If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (
੬
pg. 20).