JVC HR-A230EK - Manual (Page 39)

39
* OPERATE Button — same as button on recorder.
੬ pg. 5
( DISPLAY Button switches display between
clock time and counter readings.
੬ pg. 16
) ADD TIME Button adds time to end of record-
ing (5 minutes each time button is pressed.)
੬ pg. 20
q DAILY Button enables timer recording of daily
serials. ੬ pg. 20
w WEEKLY Button enables timer recording of
weekly serials. ੬ pg. 20
e AUX Button sets recorder's input mode.
੬ pg. 24
r TIMER Button — same as button on recorder.
੬ pg. 20
t TV PROG. +/– Button selects preset. ੬ pg. 15
y DATE +/– Button inputs date of programme for
timer recording. ੬ pg. 21
u TV/VCR Switch enables remote control of VCR
or connected TV. ੬ "Operating JVC TVs" in the
right column.
i TV/VIDEO Button switches control between TV
and VCR. ੬ "Operating JVC TVs" in the right
column.
o Fast Forward [FF] Button — same as button on
recorder. ੬ pg. 10
p PAUSE Button — same as button on recorder.
੬ pg. 11
Q STOP Button — same as button on recorder.
੬ pg. 10
W PROG CHECK Button accesses Program dis-
plays (next program's information display
appears each time button is pressed).
੬ pg. 23
E OK Button enters display selections. ੬ pg. 7
R TV VOL %fi Button controls volume of con-
nected TV. ੬ "Operating JVC TVs" in the right
column.
Installing Batteries
1 Open the battery compartment cover.
2 Insert 2 "R6"-size batteries (provided) in the correct
directions.
3 Replace the cover.
How To Use
The remote control can operate most of your video
recorder's functions, as well as basic functions of JVC TV
sets. See below.
● Point the remote control toward the sensor window.
● The maximum operating distance of the remote control
is about 8 m.
NOTE:
If for some reason the remote control doesn't work properly,
remove its batteries, wait a short time and then try again.
Operating JVC TVs
To operate your TV, set the TV/VCR switch to "TV". The
OPERATE button, TV/VIDEO button, TV PROG. +/–
buttons, TV VOL
%fi buttons and the MUTE button on the
remote control can all be used to operate the TV.
Use the NUMBER keys, and the DIGIT ENTRY (
)
button or the PUSH JOG button to select the TV's
preset.
The DIGIT ENTRY (
) button corresponds to the 1-digit/
2-digit entry switching button (often labelled -/--) on your
TV's remote control. The PUSH JOG button
corresponds
to the 10+ button, and the PUSH JOG button corre-
sponds to the 20+ button of your TV's remote control.
NOTE:
The way these buttons are used is determined by your TV.
Use these buttons as instructed for your TV's remote
control.
%%
%
%