JBL S800 - Manual (Page 12)

20A 120VAC/60Hz 2400 W
S800
10A
120V
50/60Hz
1200W
ON
OFF
MANUAL
ON
AUTO
ON
IN
OUT
Ch. 2 Output
Ch. 1
BRIDGED
Input
Ch. 2
Input
ATTENTION: VOIR LE CAHIER D'
INSTRUCTION
WARNING: HAZARDOUS ENERGY, MAKE PROPER SPEAKER CONNECTIONS; SEE OWNERS MANUAL BEFORE USING.
serial number
STEREO MONO
BRIDGED
Ch. 1 Output
BRIDGED + -
+ - + -
DESIGNED, ENGINEERED AND MANUFACTURED
IN THE UNITED STATES OF AMERICA S800 POWER AMPLIFIER JBL SYNTHESIS
NORTHRIDGE, CA TRIGGERS
AVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
~
No user serviceable parts inside. Refer
servicing to qualified personnel.
WARNING; To reduce the risk of fire or
electric shock, do not expose
this appliance to rain or moisture
11
black terminals. Wire the "+" terminal of the speaker
to the left red terminal, and the "-" terminal of the
speaker to the right red terminal.
In bridged mode, speakers connect only to the
"hot" (red) amplifier output connectors, and
neither can be connected to ground under any
circumstances, as damage to the S800 will
result.
NOTE: The minimum load impedance that this
amplifier can handle safely is two ohms per channel in
stereo operation, and four ohms in mono. Using lower
impedance loads can damage the unit and will void
your warranty!
Use the following chart as a guide to the appropriate
gage of wire to use for different amplifier-speaker
distances:
7. Circuit Breaker/Main Power Switch
The main power switch, located on the rear panel of the
S800, is also a circuit breaker. Putting this switch in
the ON position allows the amplifier to enter the "standby"
and "operate" modes as controlled by the front panel
POWER switch and Manual On/Auto On switches.
Should the amplifier be asked to produce more power
than its design allows for a prolonged period, or should
the S800 draw an amount of current from the AC power
source that could damage internal components, the
handle of this switch will move to a center position.
Reduce the audio level and wait a minute for the circuit
breaker to reset, then move it to the OFF, then the ON
position. If the handle returns to the center ("tripped")
position, service is required; contact your JBL
Synthesis dealer.
The S800 was designed to operate reliably under virtu-
ally all conditions. Even momentary short circuiting of
the output (speaker) connections will not ordinarily
damage the output circuitry (although this will activate
internal protective circuitry and cause one or more of
the front-panel blue LED indicators to extinguish until
the circuit resets.)
There are no user-serviceable parts in the S800; there
are no fuses accessible from outside the unit.
Internal fuses have been incorporated in the S800 to
protect it from short circuits and other faults, but these
should only be replaced by a qualified technician. In
case of one or more inoperative channels, call your
dealer to make service arrangements
3.0
OPERATION AND
CONTROLS
Wire Run Length Rec. Ga.
Up to 20' 16
Up to 50' 14
Up to 100' 12
Wire Run Length Minimum Gage
S800