Jwin JV-DTV37 - Manual (Page 29)

29
EN
RGB-PC Menu
You can adjust horizontal/vertical
position, clock, phase, and auto-con-
figure, reset as you prefer.
Press the MENU button and then D D / E E
button to select the SPECIAL menu.
Press the G G button and then D D / E E
button to select the desired picture
item.
Press the F F / G G button to make
appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to
left/right and up/down as you prefer.
Clock
This function is to minimize any verti-
cal bars or stripes visible on the
screen background. And the horizon-
tal screen size will also change.
Phase
This function allows you to remove
any horizontal noise and clear or
sharpen the image of characters.
Auto-configure
This function is for the automatic
adjustment of the screen position,
clock and phase. The displayed image
will disappear for a few seconds while
the Auto-configuration is in progress.
Reset
This function allows you to return to
the good picture reproduction pro-
grammed at the factory and cannot be
changed.
Note : Some signal from some graph-
ics boards may not function properly.
If the results are unsatisfactory, adjust
your monitor’s position, clock and
phase manually.
Press the OK button to store it for the
PC monitor picture.
Press the EXIT button to return to PC
mode.
PC Setup
SPECIAL
() OO }{ OO OK OO MENU
H-Pos. 0
V-Pos. 0
Clock 50
Phase 15
Auto
Reset
Language
CSM
PC Control
WXGA
VGA
Set ID
Caption
Caption/Text
PC Control
SPECIAL
() OO }{ OO OK OO MENU
1024X768
1280X768
1360X768
1366X768
Language
CSM
PC Control
WXGA
VGA
Set ID
Caption
Caption/Text
WXGA
SPECIAL
() OO }{ OO OK OO MENU
Language
CSM
PC Control
WXGA
VGA
Set ID
Caption
Caption/Text
When the set is inputted DVI-480p
signal in VGA mode, select 480p on
the special menu.
Press the MENU button and then
D D / E E button to select the SPE-
CIAL menu.
Press the G G button and then D D / E E
button to select WXGA .
Press the G G button and then D D / E E
button to select the desired WXGA
resolution.
Repeatedly press the MENU button
to return to normal TV viewing.
WXGA or VGA (Only RGB
[DVI] mode)