John Lewis JLBIDO913 - Manual (Page 12)

Clock Functions
5 6 7
1 2 3 4
1 Time
2 Cook time
3 End time
4 Countdown
5 TIME FUNCTIONS button
6 Selection button (Plus)
7 Selection button (Minus)
Countdown
To set a countdown. A signal sounds after the
time has elapsed.
This function does not affect the functioning
of the oven.
Cook time
To set how long the oven is to be in use.
End time
To set when the oven is to switch off again.
Time
To set, change or check the time (See also
section “Before Using for the First Time”).
How to use the clock functions
• After a clock function has been selected,
the corresponding function flashes for
about 5 seconds. During this period, the
desired times can be set or modified using
the or button.
• When the desired time has been set, the
function continues to flash for approx. 5
seconds. After that the function is then lit.
The set time begins to run.
• With Countdown the oven must also be
switched on in order to set the clock
function.
• By pressing and at the same time, the
time set can be reset.
Checking the time set or remaining
Press the Selection button repeatedly,
until the appropriate clock function
flashes and the time set or remaining is
displayed.
Using residual heat with the
Cook time
and End time
clock functions
When the Cook time and End
time clock functions are used, the
oven switches the heating elements
off, when 90% of the time set or
calculated has elapsed. The residual
heat present is used to continue the
cooking process until the time set has
elapsed (3 to 20 mins.).
Countdown
1. Press the "TIME FUNCTIONS" button
repeatedly until Countdown flashes.
2. Set the desired Countdown using the
or button.
After about 5 seconds the display shows
the time remaining. Countdown lights
up. When 90% of the time set has elapsed,
an audible signal sounds.
12