JL Audio Stealthbox SB-T-TUNCNSL2/10W3v3/BK - Manual (Page 5)

Specifications:
Enclosure Type: Sealed
Driver Type: 10W3v2-D2
Nominal Impedance: 4
Ω
Cont. Power Handling: 300Watts
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Included Hardware:
3) Wax Squares
3) 3/8”- 1-1/4” Fender Washer
3) 3/8” Flat Washer
3) 3/8” Split Lock Washer
3) 3/8”-16x2-1/4” Socket Cup Set Screw
3) 3/8”-16 Hex Nut
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
JL AUDIO 250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens. Input Voltage
Low/High
Left Ch. Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch. Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1 +13
+3
+7
+10
Preamp Output Section +12VDC Ground Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔ ➔
STEP 24: With the Stealthbox securely mounted
to the vehicle. Secure the plastic console to the
floor, using the factory screws from STEP 5. STEP 25: Secure the front section of console with
the factory screws, from STEP 3.
Once both portions of the center console have
been secured. Snap in the cup holders from
STEP 4, front console storage door from STEP 3
and the plastic buttons from STEP 6.
➔
S B - T- T U N C N S L 2 / 1 0 W 3 v 2 , J L AU D I O, I n c 2 0 0 5 S h e e t S K U # 0 1 1 1 8 0 R ev i s i o n 4 / 6 / 2 0 0 5 Pa g e 5 w w w . j l a u d i o . c o m
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
VR650-CSi
VR650-CXi
Front Location Driver Size:
6.5”
Applicable JL Audio Products:
TR,VR, XR, ZR 650-CSi
mounting plates are needed
Rear Location Driver Size:
6.5”
Applicable JL Audio Products:
TR,VR,XR 650-CXi
mounting plates are needed
Cont.
From
Previous
Page
Difficulty Of Installation: