John Lewis JLWM 1404 - Manual (Page 26)

Cleaning the water inlet
filters
Warning! If the appliance doesn't fill
or it is taking longer to fill with water,
check if the water inlet filters are
blocked.
1. Turn off the water tap.
2. Unscrew the water inlet hose.
3. Clean the filter using a hard bristle
brush.
4. Screw the hose back onto the tap.
5. Unscrew the hose from the machine.
Keep a rug nearby because some water
may flow.
6. Clean the filter in the valve with a stiff
brush or with the piece of cloth.
7. Screw the hose back to the machine
and make sure the connection is tight.
8. Turn on the water tap.
Emergency emptying out
If the water is not discharged, proceed as
follows to empty out the machine:
1. pull out the plug from the power
socket;
2. close the water tap;
3. if necessary, wait until the water has
cooled down;
4. open the pump door;
5. place a bowl on the floor. Remove the
emergency emptying cap from the filter.
The water should drain by gravity into
the bowl. When the bowl is full, refit
the cap into the filter. Empty the bowl.
Repeat the procedure until water stops
flowing out;
6. clean the pump if necessary as
previously described;
7. screw the pump again and close the
door.
Frost precautions
If the machine is installed in a place where
the temperature could drop below 0°C,
proceed as follows:
1. Pull out the plug from the power
socket.
2. Turn off the water tap.
3. Unscrew the inlet hose.
4. Place the end of the inlet hose in a bowl
placed on the floor, open the
emergency emptying cup of the filter
and let water drain out.
5. Refit the emergency emptying cap into
the filter and screw the water inlet hose
back.
6. When you intend to start the machine
up again, make sure that the room
temperature is above 0°C.
26