JVC XV-N650B - Manual (Page 23)

23
Remote Control Function
Remote Control C1/C2/C3 Code Switching
This unit is initially set to C3 code (JVC DVD
PLAYER code). You can easily change the
Remote Control code to C1 (JVC VCR code), C2
(JVC DVD RECORDER code) or C3 as shown
below.
• Keep pressing ENTER down during step 1.
1. Press the number Key “1” for C1, “2” for C2 or
“3” for C3 to change the remote control code.
2. Press STANDBY/ON ( 1 /\) to turn on the unit.
3. Press x on the unit for over 5 seconds while the
unit is turned on. The code currently set appears
on the front display panel.
4. Press ENTER on the remote control to change the
unit's code. The code currently set on the remote
control is displayed on the front display panel for
approximately 5 seconds, and is applied to the
unit.
Note:
If you change the batteries of the Remote Control with
C1 or C2 code, the remote control code is set to C3
automatically. In this case, you should reset the
remote control code described above.
Maintenance and Service
Refer to the information in this chapter before
contacting a service technician.
Handling the Unit
When shipping the unit
Please save the original shipping carton and packing
materials. If you need to ship the unit, for maximum
protection, re-pack the unit as it was originally packed
at the factory.
Keeping the exterior surfaces clean
• Do not use volatile liquids such as insecticide spray
near the unit.
• Do not leave rubber or plastic products in contact
with the unit for a long period of time. since they
leave marks on the surface.
Cleaning the unit
To clean the player, use a soft, dry cloth. If the
surfaces are extremely dirty, use a soft cloth lightly
moistened with a mild detergent solution.
Do not use strong solvents such as alcohol, benzine,
or thinner, as these might damage the surface of the
unit.
Maintaining the Unit
The unit is a high-tech, precision device. If the optical
pick-up lens and disc drive parts are dirty or worn, the
picture quality could be diminished.
Depending on the operating environment, regular
inspection and maintenance are recommended after
every 1,000 hours of use.
For details, please contact your nearest authorized
service center.
Reference
Reference
x
1-3
ENTER
STANDBY/ON