JVC LET0021-001A - Manual (Page 36)

English
Page 31
COMPU LINK Remote Control System
The COMPU LINK remote control system allows you to operate JVC audio components through the remote
sensor on the receiver.
To use this remote control system, you need to connect JVC audio components through the COMPU LINK-
3 SYNCHRO jacks with the cables (monaural mini-plug supplied with those components):
This remote control system allows you to use the four functions listed below.
7 7 7 7 7 Remote Control through the Remote Sensor on the Receiver
You can control JVC audio components through the remote sensor on the receiver using this remote control.
Aim the remote control directly at the remote sensor on the receiver.
For details, see page 32.
Notes:
• Without connecting the audio components with RCA pin plugs as described on page 7, the COMPU LINK
remote control system cannot operate the components.
• Refer also to the manuals supplied with your audio components.
7 7 7 7 7 Automatic Source Selection
When you press the play (
3 3 3 3 3) button on a connected component or on its own remote control, the receiver
automatically turns on and changes its source to the component. On the other hand, if you select a new source
on the receiver or the remote control, the selected component begins playing immediately.
In both cases, the previously selected source continues playing without sound for a few seconds.
7 7 7 7 7 Automatic Power On/Off (Standby) (only possible with the COMPU LINK-3 connection)
Both the CD player and cassette deck turn on and off (into standby mode) with the receiver.
When you turn on the receiver, the CD player or cassette deck will turn on automatically, depending which
component has been previously selected.
When you turn off the receiver (into standby mode), both the CD player and cassette deck will turn off (into
standby mode).
7 7 7 7 7 Synchronized Recording
Synchronized recording means the cassette deck starts recording as soon as a CD or record begins playing.
To use synchronized recording, follow these steps:
1
Put a tape in the cassette deck, and a disc in the CD player (or a record on the turntable).
2 Press the record ( ¶) button and the pause (8) button on the cassette deck at the same time.
This puts the cassette deck into recording pause.
Note:
If you do not press the record (
¶) button and pause (8) button at the same time, the synchronized recording
feature will not operate.
3 Press the play ( 3) button on the CD player or on the turntable.
The source changes on the receiver, and as soon as play starts, the cassette deck starts recording.
When the play ends, the cassette deck enters recording pause, and stops 4 seconds later.
Notes:
• During synchronized recording, the selected source cannot be changed.
• If your CD player is playing in program mode, a 4-second blank is recorded between tracks so that the music
scan feature of your cassette deck can be used on the recorded tape.
• If the power of any component is shut off during synchronized recording, the COMPU LINK remote control
system may not operate properly. In this case, you must start again from the beginning.
• Refer also to the manuals supplied with your CD player and cassette deck.
COMPU LINK – 3
SYNCHRO
Cassette deck CD player
Turntable
RX-530RBK(EF)_0021-001A_En 97.4.24, 0:31 PM 31